COe sensor, thermocouple, and heater connectionsFigure 9-19:
A. All wires at these terminals are in the CJC current loop.
11. Install and fasten the COe insulator (A, Figure 9-15) around the COe sensor assembly
(I).
All wiring must remain outside of the insulator.
12. If terminal block mounting (F, Figure 9-15) was moved, reinstall it with two base
mounting screws.
Install sample block heater rods
Complete the following steps to install the sample block heater rods in the OCX 8800.
Maintenance and service
Reference Manual 243
To Next Page
Loading...
