2.5 Pneumatic Installation .......................................................................................... 30
2.5.1 Reference Air Set Option (only) ............................................................. 30
2.5.2 Reference Air Set and Solenoids Option without COe Zero Function ...... 33
2.5.3 Reference Air Set and Solenoids Option with COe Zero Function ............ 33
2.5.4 Reference Air Set, Solenoids, and Blowback Option with
COe Zero Function35
2.5.5 Reference Air Set, Solenoids, and Blowback Option without
COe Zero Function35
2.5.6 Reference Air Set, Solenoids, and Blowback Option with COe Zero Function
38
2.5.7 Reference Air Set and Blowback Panels .................................................. 38
2.6 Initial Startup ....................................................................................................... 42
Section 3: Configuration and Startup
3.1 Section contents .................................................................................................. 43
3.2 Verify Installation. ................................................................................................ 43
3.2.1 Verify Configuration - HART Electronics ................................................ 43
3.2.2 Verify Configuration - Fieldbus Electronics ............................................. 45
3.3 Initial Power Up .................................................................................................... 46
3.4 Set Test Gas Values ............................................................................................... 46
3.4.1 Setting Test Gas Values with the Field Communicator ........................... 46
3.4.2 Setting Test Gas Values with Fieldbus Communicator ............................ 46
3.4.3 Setting Test Gas Values with the LOI ...................................................... 47
3.5 Calibration Solenoids ............................................................................................ 47
3.5.1 Configuring the Calibration Solenoids with the Field
Communicator - HART .......................................................................... 47
3.5.2 Configuring the Calibration Solenoids with the Field
Communicator - Fieldbus ...................................................................... 47
3.5.3 Configuring the Calibration Solenoids with the LOI ................................ 48
3.6 Blowback Feature ................................................................................................. 48
3.6.1 Configuring Blowback with the Field Communicator - HART. ................. 48
3.6.2 Use the 375 Field Communicator or AMS software ...................................
to access the Fieldbus menu. ................................................................. 48
3.6.3 Configuring Blowback with the LOI ........................................................ 49
3.7 Calibration Verify Feature ..................................................................................... 49
3.7.1 Performing a Calibration Verify with the Field Communicator - HART..... 50
3.7.2 Performing a Calibration Verify with the Field Communicator - Fieldbus 50
3.7.3 Performing a Calibration Verify with the LOI .......................................... 51
3.8 Calibration Tolerance Feature ............................................................................... 52
3.8.1 Configuring the Calibration Tolerance Feature with the Field ....................
Communicator - HART.......................................................................................... 52
3.8.2 Configuring the Calibration Tolerance Feature with the Field ....................
Communicator - Fieldbus ..................................................................................... 52
3.8.3 Configuring the Calibration Tolerance Feature with the LOI ................... 52
3.9 COe Purge/ Zero Feature ...................................................................................... 53
3.9.1 Configuring the COe Zero Feature with the Field
To Next Page
Loading...
