Emerson RSTi-OM - Section 10: Using the Diagnostics; IO-Link Port Diagnostics

RSTi-OM User Manual Section 9
GFK-3212A Jun 2021
PROFINET IO Reference Information
91
Section 9: Using the Diagnostics Pages
This section provides information about the following Diagnostics pages:
• IO-Link Port Diagnostics (Section 9.1)
• PROFINET IO Diagnostics Page (Section 9.2)
• Modbus/TCP Diagnostics (Section 9.3)
• OPC UA Diagnostics Page (Section 9.4)
• MQTT Diagnostic Page (Section 9.5)
9.1 IO-Link Port Diagnostics
Use the IO-Link Diagnostics page to determine the status of the IO-Link configuration.
Figure 80: IO-LINK Diagnostics
The following table provides information about the IO-Link Diagnostics page.
IO-Link Diagnostics
Port Name
This is an optional friendly port name, which can be
configured in the
Configuration | IO-Link page.
Port Mode
Displays the active device mode:
Reset = The port is configured to disable all functionality.
IO-Link = The port is configured to IO-Link mode.
Digital In = The port is configured to operate as a digital
input.
Digital Out = The port is configured to operate as a digital
output.