RSTi-OM User Manual Section 9
GFK-3212A Jun 2021
PROFINET IO Reference Information
93
Automatic Data Storage
Configuration
Displays whether a port is configured to automatically upload
data from the IO-Link device or download data from the IOLM
to the IO-Link device.
Disabled displays if automatic upload or download are not
enabled.
Auxiliary Input (AI) Bit Status
The current status of the auxiliary bit as received on DI (Pin 2
on the IOLM) of the IO-Link port.
The supported Device PDI Data Length, in bytes, as stored in
ISDU Index 0.
Current status of PDI data as received from the IO-Link device.
Last Rx PDI Data (MS Byte
First)
The last Rx PDI data was received from the IO-Link device.
If enabled on the Configuration| IO-Link Settings page, an
industrial protocol application (PROFINET IO, EtherNet/IP, or
Modbus TCP) can lock the write access to the PDO value so
that the PDO value cannot be changed by other protocols
(including OPC UA or the Web interface). Such a lock is
released when the PLC to IO-Link Master network link
disconnects.
Indicates whether or not one of the industrial protocol
applications has locked the write access to the PDO value.
The supported Device PDO Data Length, in bytes, as stored in
ISDU Index 0.
Status of PDO data being received from the controller(s).
Last Tx PDO Data (MS Byte
First
Time Since Initialization
The time since the last port initialization.
The number of process data errors the port received.
The number of process data retries the port performed.
The total number of events that were received on this port.
Up to the first, or oldest, three events that were received on
this port.
Up to the last, or most recent, three events that were received
on this port.
The number of read ISDU command attempts.
The number of read ISDU command errors.
The number of write ISDU command attempts.
The number of write ISDU command errors.