Emerson Unidrive HS30 - Page 42

42 Unidrive M300/HS30 Quick Start Guide
Issue Number: 6
Defines the serial baud rate of the drive
Changing the parameters does not immediately change the serial communications settings. See
Reset Serial Communications (00.045) for more details.
Used to define the unique address for the drive for the serial interface. The drive is always a slave
address 0 is used to globally address all slaves, and so this address should not be set in this
parameter.
Changing the parameters does not immediately change the serial communications settings. See
Reset Serial Communications (00.045) for more details.
Set to On (1) to update communications set-up.
00.043 {11.025} Serial Baud Rate
RW Txt US
OL
Ú
300 (0), 600 (1), 1200 (2),
2400 (3), 4800 (4), 9600 (5),
19200 (6), 38400 (7),
57600 (8), 76800 (9),
115200 (10)
Ö
19200 (6)
RFC-A
00.044 {11.023} Serial Address
RW Num US
OL
Ú
1 to 247
Ö
1
RFC-A
00.045 {11.020} Reset Serial Communications
RW Bit ND NC US
OL
Ú
Off (0) or On (1)
Ö
Off (0)
RFC-A
The display will briefly display On and return to Off on reset.
NOTE
Unidrive M300 Quick Start Guide English Iss6.book Page 42 Tuesday, September 22, 2015 3:21 PM