Emerson UNIDRIVE M600 - Page 103

SI-Ethernet User Guide 103
Issue: 1
Safety
information
Introduction
Mechanical
installation
Electrical
installation
Getting started Parameters
Key features
and Protocols
PC Applications Security Diagnostics
Glossary of
terms
Index
This parameter defines the type of motor 2.
6.1.8 Menu 21 – EtherNet/IP In Mappings
This menu contains the parameters used to define the source parameters for data that
will be transmitted to the PLC.
S.20.041 Type of motor 2
Minimum 0 Maximum 4
Default 2 Units
Type 8 Bit User Save Update Rate Reset
Display Format None Decimal Places 0
Coding RO, TE, PT, BU
Value Text Description
0 2-FC DC FC DC Motor
1 6-WRI Wound Rotor Induction Motor
2 7-SCI Squirrel Cage Induction Motor
3 9-Sin PM BL Sinusoidal PM BL Motor
4 10-Trap PM BL Trapezoidal PM BL Motor
S.21.001 Input mapping parameter 1
Minimum
0
(Display: 0.00.000)
Maximum
499999
(Display: 4.99.999)
Default
10040
(Display: 0.10.040)
Units
Type 32 Bit User Save Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/
IP interface enable
Display Format Slot Menu Param Decimal Places 0
Coding RW, DE, PT, BU
S.21.002 Input mapping parameter 2
Minimum
0
(Display: 0.00.000)
Maximum
499999
(Display: 4.99.999)
Default
2001
(Display: 0.02.001)
Units
Type 32 Bit User Save Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/
IP interface enable
Display Format Slot Menu Param Decimal Places 0
Coding RW, DE, PT, BU