Emerson UNIDRIVE M600 - Page 58

58 SI-Ethernet User Guide
Issue: 1
This parameter sets the source parameter for the Tx2 link.
This parameter is used to set the number of contiguous parameters for the Tx2 link.
This specifies the type of transmission for the Tx2 link.
S.10.022 Tx2 Source Parameter
Minimum
0
(Display: 0.00.000)
Maximum
499999
(Display: 4.99.999)
Default
0
(Display: 0.00.000)
Units
Type 32 Bit User Save Update Rate Read on reset
Display Format Slot Menu Param Decimal Places 0
Coding RW, PT, BU
S.10.023 Tx2 Parameter Count
Minimum 0 Maximum 10
Default 0 Units
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, BU
S.10.024 Tx2 Link Transmission Type
Minimum 0 Maximum 5
Default 0 Units
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, TE, BU
Value Text Description
0 Unicast Link is unicast to the IP address specified
1 Broadcast Link is broadcast (255.255.255.255)
2 Multicast1 Link is multicast to the IP address (239.255.0.1)
3 Multicast2 Link is multicast to the IP address (239.255.0.2)
4 Multicast3 Link is multicast to the IP address (239.255.0.3)
5 Multicast4 Link is multicast to the IP address (239.255.0.4)