Emerson Unidrive M700 - Page 59

SI-Ethernet User Guide 59
Issue: 1
Safety
information
Introduction
Mechanical
installation
Electrical
installation
Getting started Parameters
Key features
and Protocols
PC Applications Security Diagnostics
Glossary of
terms
Index
This parameter specifies the IP address of the destination device for the Tx2 link. If Tx2
Link Transmission Type (S.10.024) is set to either broadcast or one of the multicast
settings this parameter will display the appropriate address.
Defines, in milliseconds, the rate at which Tx2 Link will be transmitted. A value of zero
disables the transmission of data.
S.10.025 Tx2 Destination Address
Minimum
0
(Display:0.0.0.0)
Maximum
4294967295
(Display: 255.255.255.255)
Default
0
(Display:0.0.0.0)
Units
Type 32 Bit User Save Update Rate Read on reset
Display Format IP Address Decimal Places 0
Coding RW, BU
This parameter value is not locked and may be changed by the user, if this value is
changed to any of the multicast addresses (Multicast1, Multicast2, Multicast3 or
Multicast4) or the broadcast address then Tx2 Link Transmission Type (S.10.024) will
indicate the appropriate setting.
S.10.026 Tx2 Message Rate
Minimum 0 Maximum 100
Default 0 Units ms
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, BU
S.10.029 Tx2 Link Status
Minimum -30 Maximum 2
Default 0 Units
Type 8 Bit Volatile Update Rate Write on reset
Display Format None Decimal Places 0
Coding RO, TE
NOTE