Emerson Unidrive M700 - Page 62

62 SI-Ethernet User Guide
Issue: 1
This parameter specifies the type of transmission for the Tx3 link.
This parameter specifies the IP address of the destination device for the Tx3 link. If Tx3
Link Transmission Type (S.10.034) is set to either broadcast or one of the multicast
settings this parameter will display the appropriate address.
Defines, in milliseconds, the rate at which Tx3 Link will be transmitted. A value of zero
disables the transmission of data.
S.10.034 Tx3 Link Transmission Type
Minimum 0 Maximum 5
Default 0 Units
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, TE, BU
Value Text Description
0 Unicast Link is unicast to the IP address specified
1 Broadcast Link is broadcast (255.255.255.255)
2 Multicast1 Link is multicast to the IP address (239.255.0.1)
3 Multicast2 Link is multicast to the IP address (239.255.0.2)
4 Multicast3 Link is multicast to the IP address (239.255.0.3)
5 Multicast4 Link is multicast to the IP address (239.255.0.4)
S.10.035 Tx3 Destination Address
Minimum
0
(Display:0.0.0.0)
Maximum
4294967295
(Display: 255.255.255.255)
Default
0
(Display:0.0.0.0)
Units
Type 32 Bit User Save Update Rate Read on reset
Display Format IP Address Decimal Places 0
Coding RW, BU
This parameter value is not locked and may be changed by the user, if this value is
changed to any of the multicast addresses (Multicast1, Multicast2, Multicast3 or
Multicast4) or the broadcast address then Tx3 Link Transmission Type (S.10.034) will
indicate the appropriate setting.
S.10.036 Tx3 Message Rate
Minimum 0 Maximum 100
Default 0 Units ms
Type 8 Bit User Save Update Rate Read on reset
Display Format None Decimal Places 0
Coding RW, BU
NOTE