Emerson Unidrive M700 - Page 97

SI-Ethernet User Guide 97
Issue: 1
Safety
information
Introduction
Mechanical
installation
Electrical
installation
Getting started Parameters
Key features
and Protocols
PC Applications Security Diagnostics
Glossary of
terms
Index
This parameter defines and shows the required input assembly object.
This parameter defines and shows the required output assembly object.
S.20.018 Active input assembly object
Minimum 0 Maximum 4
Default 0 Units
Type 8 Bit Volatile Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/
IP interface enable
Display Format None Decimal Places 0
Coding RO, TE, NC, PT, BU
Value Text Description
0 100-PrimaryI Primary input (100)
1 70-BscSpdCtrlI Basic speed control input (70)
2 71-ExtSpdCtrlI Extended speed control input (71)
3 72-SpdTqCtrlI Speed and torque control input (72)
4 73-ExtSpdTqCtrlI Extended speed and torque control input (73)
S.20.019 Active output assembly object
Minimum 0 Maximum 4
Default 0 Units
Type 8 Bit Volatile Update Rate
Module reset, EtherNet/IP
interface reset or EtherNet/
IP interface enable
Display Format None Decimal Places 0
Coding RO, TE, NC, PT, BU
Value Text Description
0 101-PrimaryO Primary output (101)
1 20-BscSpdCtrlO Basic speed control output (20)
2 21-ExtSpdCtrlO Extended speed control output (21)
3 22-SpdTqCtrlO Speed and torque control output (22)
4 23-ExtSpdTqCtrlO Extended speed and torque control output (23)