Emerson VCR872 - Remote Control Operation; Battery Installation

REMOTE CONTROL OPERATION
BATTERY INSTALLATION
' Use two size 'R03/AAA/UM-4' batteries.
(1) Slide the cover of the battery compartment in
the direction of the arrow and remove.
(2) Load the two batteries as shown below and
replace the cover.
Make sure that the polarities. + and are
properly aligned.
CHANNEL NUMBER FILM TAB
A miniture polyester film tab sheet with channel
VHF/UHF and CATV numbers to stick on
Remote control buttons after the channels are
being preset, is provided for direct access to
selecting channels.
NOTE
• Do not use a new battery with an old one or
a different one.
• Do not heat, disassemble, short, recharge
and throw batteries into a fire.
• Be careful not to spill liquids into the inside.
• Do not drop and shock it.
• Do not put heavy things on it.
• A short effective operating distance means
weak batteries.
Replace weak batteries with fresh ones.
• Weak batteries can leak and severely dam 
age the REMOTE CONTROL unit. Always
remove batteries as soon as they become
weak or if the unit is not be used for a long
time.
— 29 -