Emerson VCR872 - Connections with Other Equipment; Duplicating a Video Tape

CONNECTION WITH OTHER EQUIPMENT
CONNECTION TO THE TV WITH AUDIO/VIDEO JACKS.
The standard connections are descibed on page 8. If, however, your TV has AUDIO/VIDEO jacks and
you connect them to the VCR as shown below you receive better quality pictures and sound.
In this case, set TV input select switch to video position. (No need to set the VCR/TV select switch to
VCR position.)
CONNECTION TO THE STEREO EQUIPMENT
If you connect to the stereo equipment, you can playback sound from the speaker of the stereo equip 
ment.
AUDIO cord (not supplied)
DUPLICATING A VIDEO TAPE
If you connect the VCR to another one, you can duplicate a pre-recorded tape.
■ It is recommended that you should set the TAPE SPEED to SP mode on the recording VCR.
■ When you playback the duplicated tape, adjust the PICTURE control to SOFT position to get the
better picture.
• Press the REC button on recording VCR, then press the PAUSE/STILL button.
• Press the PLAY button on playback VCR, then press the PAUSE/STILL button.
• Press the PAUSE/STILL button on the both VCRs simultaneously.
NOTE
After duplicating, disconnect the cable from the AUDIO/VIDEO IN jacks.
You cannot record TV program if you keep the connections.
THE VIDEO AND AUDIO JACKS CAN BE USED TO CONNECT THE VCR TO OTHER
AUDIO OR VIDEO UNIT.
The VIDEO IN and AUDIO IN jacks have priority over other inputs. Recording of broadcasts with the
VCR tuner is not possible when the VIDEO and AUDIO input jacks are in use.
— 30 —