Emerson White Rodgers 36H Series - System Wiring; Non-Piloted Applications Wiring; Proven;Intermittent Pilot Applications Wiring; Terminal Identification

5
SYSTEM WIRING
REFER TO AND FOLLOW THE APPLIANCE MAN-
UFACTURER’S WIRING DIAGRAM. REFER TO
FIG. 4 AND 5 FOR TERMINAL IDENTIFICATION.
These valves are shipped with an external jumper
installed for non-piloted gas applications.
• For non-piloted gas applications HSI and DSI,
connect common wire to (C) terminal and hot
wire to external jumper (MP) terminal
(see g. 4 and 5).
NOTE
All wiring should be installed in accordance with local and national electrical codes and ordinances.
Always check that the electrical power supply used agrees with the voltage and frequency shown on
the gas control.
INSTALLATION
Figure 4.FeaturesandTerminalIdentication
REGULATOR COVER SCREWS
(REG. ADJ. BENEATH THESE
SCREWS)
TERMINAL – M (MAIN)
TERMINAL –
P (PILOT/REDUNDANT)
TERMINAL – C (COMMON)
TERMINAL – HI (2ND STAGE COIL)
PILOT GAS OUTLET
PLUG OR FITTING
CENTERLINE OF
INLET & OUTLET
Note: All dimensions indicated in inches
INLET PRESSURE TAP
1/8” - 27 NPT
OUTLET PRESSURE TAP
1/8” - 27 NPT
OUTLET 3/4” - 14 NPT
1.63 .32
.19
1.45
.88
3.77
1.375
1.20
1.63
3.26
1.375
1.13
.03
VENT PLUG
1/8”-27 NPT
INLET 3/4” - 14 NPT
or 1/2” - 14 NPT
4.20 R
SWING RADIUS
3.98 INLET TO
OUTLET
3/16
” GROUND
TERMINAL
ON/OFF SWITCH
PILOT ADJUSTMENT
COVER SCREW
(PILOT ADJ. BENEATH
THIS SCREW)
COMMON
C
PILOT
P
EXTERNAL
JUMPER
MAIN
M
MP
PILOT
REDUNDANT
VALVE
TWO STAGE
MODELS ONLY
2ND
STAGE
VALVE
MAIN
VALVE
HI
ON/OFF
SWITCH
Figure 5.SimpliedGasValveInternalWiringandTerminalIdentication
• For proven/intermittent pilot gas applications
such as intermittent pilot or spark-to-pilot sys-
tems, remove the external wire jumper from the
main (M) and pilot (P) valve terminals and con-
nect wires accordingly (see g. 4 and 5).