Document Part # 026-4280 Rev 1 Page 32 of 33
©2022 Emerson Digital Cold Chain, Inc. This document may be photocopied for personal use.
Visit our website at www.climate.emerson.com for the latest technical documentation and updates.
Hd3 nu Pr1 Third weekly day
ILE 0.0 Pr1 Energy saving cycle start during workdays
dLE 0.0 Pr1 Energy saving cycle length during workdays
ISE 0.0 Pr1 Energy saving cycle start during holidays
dSE 0.0 Pr1 Energy saving cycle length during holidays
Ld1 6.0 Pr1 Workdays First defrost start
Ld2 13.0 Pr1 Workdays Second defrost start (minimum as Ld1)
Ld3 21.0 Pr1 Workdays Third defrost start (minimum as Ld2)
Ld4 nu Pr1 Workdays Fourth defrost start (minimum as Ld3)
Ld5 nu Pr1 Workdays Fifth defrost start (minimum as Ld4)
Ld6 nu Pr1 Workdays Sixth defrost start (minimum as Ld5)
Sd1 6.0 Pr1 Holidays First defrost start
Sd2 13.0 Pr1 Holidays Second defrost start
Sd3 21.0 Pr1 Holidays Third defrost start
Sd4 nu Pr1 Holidays Fourth defrost start
Sd5 nu Pr1 Holidays Fifth defrost start
Sd6 nu Pr1 Holidays Sixth defrost start
HES 0.0 Pr1 Temperature increasing during Energy Saving
PEL n Pr1 Energy saving activation when Light switched off
LMd y Pr2 Defrost Synchronization
dEM y Pr2 Defrost end Synchronization
LSP n Pr2 Setpoint Synchronization
LdS n Pr2 Display Synchronization (temperature sent via LAN)
LOF n Pr2 ON/OFF Synchronization
LLi y Pr2 Light Synchronization
LAU n Pr2 AUX Synchronization
LES n Pr2 Energy Saving Synchronization
LSd n Pr2 Remote probe displaying
LCP n Pr2 P4 probe sent via LAN
StM n Pr2 Cooling request from LAN enable compressor relay
ACE n Pr2 Cold Calling in LAN always enabled even if the compressor block
P1C ntc Pr2 P1 configuration
OF1 0.0 Pr2 P1 calibration
P2C ntc Pr2 P2 configuration
OF2 0.0 Pr2 P2 calibration
P3C nu Pr2 P3 configuration
OF3 0.0 Pr2 P3 calibration
P4C nu Pr2 P4 configuration
OF4 0.0 Pr2 P4 calibration
LCL y Pr2 Light on during cleaning mode
Label M1 M2 M3 M4 Menu Parameters Description
Table 17-1 - Default Setting Values
To Next Page
Loading...
