6 • XM679K I&O Manual 026-1218 Rev 4
4 Fast Access Menu
This menu contains the lists probes and some values that are automatically evacuated by the board, such as the
superheat and the percentage of valve opening. The values below stands for:
• nP or noP - probe not present or value not evacuate
• Err - value out of range, probe damaged, not connected or incorrectly configured
FAST ACESS MENU
HM Fast Access Menu to Clock Settings (If present)
An
Fast Access to Analog Output
Reading
(If present)
SH Superheat Shows the actual superheat value (Only XM679)
oPP Valve opening percentage Shows the actual opening percentage of the valve (Only XM679)
dP1 Probe 1 value displaying Shows the temperature measured by probe 1
dP2 Probe 2 value displaying Shows the temperature measured by probe 2
dP3 Probe 3 value displaying Shows the temperature measured by probe 3
dP4 Probe 4 value displaying Shows the temperature measured by probe 4
dP5 Probe 5 value displaying Shows the temperature measured by probe 5
dP6 Probe 6 value displaying Shows the temperature measured by probe 6
dPP Pressure probe value
Shows the value of pressure measured by pressure transducer
(Only XM679)
rPP Remote pressure probe value
Shows the value of pressure received by remote pressure probe
connected to other XM600 device (Only XM679)
L°t Minimum measured temperature Shows the minimum temperature read by the regulation probe
H°t Maximum measured temperature Shows the maximum temperature read by the regulation probe
dPr Virtual regulation probe value Shows the value measured by the virtual regulation probe
dPd Virtual defrost probe value Shows the value measured by the virtual defrost probe
dPF Virtual fans probe value Shows the value measured by virtual fan probe
rSE Real setpoint
Shows the setpoint used during the energy saving cycle or during
the continuous cycle
Table 4-1 - Fast Access Menu
To Next Page
Loading...
