Rev. 3 02-2021
5
MTEC.DXi.H/DXi.HF.GB-3 Use and Maintenance technical manual DXi.H/DXi.HF English
Emibyte DXi.H/DXi.HF Direct expansion close control
1. INTRODUCTION
3UHOLPLQDU\LQIRUPDWLRQ
,QVWUXFWLRQVFRQWHQWDQGSRXUSRVH
,QVWUXFWLRQFRQVHUYDWLRQ
,QVWUXFWLRQXSGDWLQJ
,QVWUXFWLRQXVH
The copy, transmission or memorisation of the present Manual is forbidden in any form without the written authorisation from the Manufac-
turer.
The unit which the present Manual refers is designed only for the uses presented in the following pages, comply with their performances
and characteristics. Any contractual or extra-contractual liability of the Manufacturer for damages caused to people, animals, thigs or envi-
ronment made by installation, regulation, maintainence errors or improper uses are excluded
All the uses not mentioned in the present Manual are not allowed.
The present documentation is an informative support and has not to be considered as a contract with third parts.
7KH0DQXIDFWXUHUZRUNVLQDFRQVWDQWSROLF\RISURGXFWVGHYHORSPHQWDQGUHVHUYHVWKHULJKWWRPRGLI\KLVSURGXFWVWKHVSHFL¿FVWKH
instructions and also the documentation in any moment without any prior notice
The present instructions porpose to give all information concerning the selection, installation, use and maintenance of the units.
The instructions are written in conformity with legislative disposition of UE and to the technical available norms.
The instructions including the indication to avoid reasonably foreseeable improper uses of the units.
The instruction must be posed in a proper place, away from dust, humidity and where every person in charge to use and operate with the
XQLWFRXOG¿QGWKHPHDVLO\
The instruction has to be always on board and during all the life cycle of the unit, therefore has to be transferred to every subsequent user
Is suggested to verify that all the instructions are updated to the last release available.
Any updates sended to the user must be kept attached to the present Manual.
The Manufacturer is available to provide any information about use of his products.
The present instructions are integral part of the unit which are referred.
The users and operators have to consults mandatory the instructions before any intervention on the unis and in every
occasion of doubt about the transport, the handling, the installation, the maintenance, the use and the disposal of the unit.
In the following are mentioned all the graphic symbols which indicate all the operation has to be safety done
To Next Page
Loading...
Need help?
General