EasyManua.ls Logo

Emmaljunga Scooter 4 - Care and Maintenance - Continued; Washing Instructions for Components; Ironing and Reassembly After Washing

Emmaljunga Scooter 4
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46
Manual Scooter 4 / Scooter 4 S v. 4.7
Care and maintenance
Washing instructions
Hood:
Take off and extend the hood. Spray the hood with lukewarm water. Use a mild liquid soap. Cleanse
thoroughly. Drip dry the hood, fully extended.
Fabric and 5-point harness:
Remove the fabric from the chassis. Hand wash fabric in lukewarm water. Use a mild liquid soap. Cleanse
thoroughly. Drip dry the fabric. Only wipe the 5-point nylon harness and plastic parts clean with a damp
cloth. Do not hand wash. Make sure the harness is dry before retting.
Front bar and front bar protection cover:
Remove the cover from the front bar. Hand wash in lukewarm water. Use mild liquid soap on the exterior
surface of the front bar fabric. Handle non-woven interior material with care. Drip-dry.
General Information
Ironing: If any fabric part needs to be ironed, always use a 100 % cotton cloth in between the iron and the
fabric to protect the fabric surface. Iron the exterior fabrics (100 %) polyester and the interior fabrics on a
gentle heat (110°C on the iron).
Make sure all parts are completely dry before reassembly. Check the trimmings and the seam on the un-
derside of the seat-fabric and on the backrest pocket.
You may apply a material protector (like Scotchgard™) on the exterior fabric after washing. Always apply
before reassembly.
WARNING
Do not place child/children in stroller for at least 24 hours after applying a material protector.
Reassembly after washing
WARNING
Make sure all parts are reassembled correctly according to the instructions in this manual.
Make sure the seat-board and the footrest-board are correctly positioned before reassembly and use.

Table of Contents

Related product manuals