emmeti SHARK E - Page 36

36
7. SPARE PARTS
GBGB
6. MAINTENANCE/FAULTS
Code Fault Cause Remedy
E 04 Undervoltage
Power supply too low on mains
side.
Check mains voltage.
E 05 Overvoltage
Power supply too
high on mains side.
Check mains
voltage.
E 07 Generator operation
Water is flowing
through the pump
hydraulics, but pump
has no mains voltage.
Check mains
voltage.
E 10 Blocking The rotor is blocked
Contact specialist
technician
E 11 Dry running Air in the pump
Check water quantity/
pressure.
E 21 Overload Sluggish motor
Contact specialist
technician
E 23 Short-circuit
Motor current too
high
Contact specialist
technician
E 25
Contacting/
winding
Winding defective
Contact specialist
technician
E 30 Module overheated
Module interior too
warm
Check operating
conditions in chapter
2.
E 36 Module defective
Electronic components
defective
Contact specialist
technician
Fault signals