LED declaration
emmi®-dent Platinum & emmi®-dent Platinum Care
LED 3b
LED 5
LED 4
LED 3a
LED 2
LED 1
Functions of the LEDs:
a) Charging control function LED2
Blue LED: emmi®-dent is on the charging station
Light blue light: emmi®-dent in charging process
Weak blue light: emmi®-dent is fully charged
b) Battery status
(LED1, LED3a, LED5 & LED3b)
The three green LEDs (and the white LED on
the brush head) are used in the manner of a
sequential light during the cleaning process.
Is the battery fully charged, the LEDs light up
as follows:
• LED1, LED3a, LED5 + LED3b
If the battery is approx. 1/3 discharged, the
following LEDs light up in sequence:
• LED1, LED3a + LED3b
If the battery is approx. 2/3 discharged, only
the following LED lights up:
• LED1
c) „Urgent recharge“ indicator
If the battery is heavily discharged, the LED4
flashes red a few times after the cleaning
process. Please charge the emmi®-dent.
d) Switching between vibration and acoustic
signal (except emmi®-dent Platinum Care)
If the On button of the emmi®-dent is pressed
for approx. 10 seconds, the LED2 flashes red
and the vibration as well as the acoustic signal
are switched off.
Press and hold down the On button for approx.
10 seconds, and the LED2 flashes green. The
vibration as well as the acoustic signal are swit-
ched on now.
To Next Page
Loading...