EasyManua.ls Logo

Emos P2313 - LED Plastic Flashlight Technical Specifications; Technical Specifications; Charging the Accumulator; Quick Switch-off Function

Emos P2313
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
GB | LED Plastic Flashlight
Technical Specications
Light source: LED + SMD LED
Accumulator: 2× 2 000 mAh/3.7 V Li-ion 18650
Flashlight charging temperature: 0 °C to +40 °C
IP44
Charging the Accumulator
The ashlight‘s accumulator must be recharged before rst use. Charge the ashlight in dry indoor
areas at a temperature of 0 °C to +40 °C. If the ashlight is not used for an extended period of time,
it is necessary to recharge the accumulator before further use. The accumulator self-discharges
and must be recharged at least once every 3 months to prevent its voltage from dropping and the
accumulator potentially being rendered unusable. After recharging, disconnect the adapter from
the ashlight and the mains. Charging a fully depleted accumulator takes approximately 7 hours.
Quick Switch-o Function
This function will make switching o a Work Light with multiple lighting modes much
easier. Simply use whichever lighting mode you need and then turn o the Work Light
when you‘re done with a single button press – no need to go through all the remaining
lighting modes to turn the Work Light o.
1. Turn on the Work Light.
2. Choose the lighting mode that suits you best.
3. The quick switch-o function automatically activates if the Work Light remains in the same
lighting mode for 10 seconds.
4. Afterwards, another press of the button automatically turns the Work Light o (skips the other
lighting modes).
Rechargeable Battery Protection
A product with this function features protective circuits that prevent both overcharging
and excessive discharging of the accumulator that could lead to high temperatures,
sparking or explosion that would irreversibly damage or destroy the product.
WARNING
If water enters the interior of the ashlight, remove the accumulator and dry the interior of the
ashlight thoroughly. Do not under any circumstances use the ashlight.
LED
330 lm 10 h 260 m
180 lm 17 h 170 m
SMD LED
100 lm 13 h 7 m
180 lm 8 h 10 m
350 lm 5 h 15 m
SMD LED RED
10 lm 23 h 3 m
Flashing, blikání, blikanie, miganie, villogás, utripanje,
treperenje, Blinken, мигання, clipire, mirgošana,
mirgėjimas, vilkumine, мигане

Related product manuals