Emperor Ninja - Channel Memory and Key Lock; PTT Operation and External Connectors; Frequency Band Selection

33
CHANNEL MEMORY ~ M1/M2/M3/M4
The CB can store and recall, when necessary, 4 channels previously stored in the
memory.
To store or recall a channel into the memory, use the following procedure.
• Select the channel with the appropriate control or the UP / DOWN buttons
on the microphone.
• Push the F button : the display will show
.
• Press and release M1 button for recall memory channel.
• Press and hold the M1 button during 2 seconds. The unit will store a new
memory, you will hear a « BEEP » and the display will show
.
11)Lock button
it allows you to lock / unlock the key buttons.
12)PTT (push to talk):
Depress this knob to transmit a message and release to listen to an incoming
communication.
A) DC-POWER TERMINAL (13,2 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL S-METER JACK (Ø 2,5 mm)
D) EXTERNAL SPEAKER JACK (8
ΩΩ
ΩΩ
Ω , Ø 3,5 mm)
FREQUENCY BAND SELECTION
The frequency bands must be chosen according to the country where you
are going to operate. Do not use another configuration. Some countries
require user’s licence.
Procedure :
1. Switch off the unit.
2. Turn it on while pushing the F and 19/9 buttons at the same time.
3. Rotate the Channel knob and select the desired frequency band (See the
chart here below)
4. To stop your selection, press the F button.
NOTE : In the EU/UK , you can select directly the EU or UK band by pushing the
AM/FM button.
FREQUENCY BAND CHART
Digits displayed Country
I Italy 40 CH AM/FM 4 Watt
I2 Italy 34 CH AM/FM 4 Watt
D Germany 80 CH FM 4 Watt/ 80 CH AM 1 Watt
D2 Germany 40 CH FM 4 Watt/ 40 CH AM 1 Watt
EU Europe 40 CH FM 4 Watt/ 40 CH AM 1 Watt
EC CEPT 40 CH FM 4 Watt
E Spain 40 CH AM/FM 4 Watt
F France 40 CH FM 4 Watt / 40 CH AM 1 Watt
PL Poland 40 CH AM/FM 4 Watt
UK England 40 CH FM 4 Watt English frequencies
EU/UK Europe 40 CH FM 4 Watt + England 40 CH FM 4 Watt
English