4. Plug the end of the sensor’s cord into the jack labeled SENSOR on the control box
Make sure you have it plugged in all the way, there should be no gaps. Next plug
one end of the included double ended male to male cord into the jack labeled
DEVICE on the control box. The other end will plug into your switch adapted device.
5. To attach the sensor Flex Arm to your glasses use the included heat shrink tubing
around one frame arms leaving enough space for positioning the sensor where you
want it. (See Photos )You will want to cut the tubing to fit the length of your glasses’
arm and then using a heat gun or hair dryer heat the tubing so it shrinks around the
arm. (Caution Do not over heat (See Photos).
Photos
Page No.2
To Next Page
Loading...