27
(seat has time delay kill switch to prevent
cut-outs on rough terrain).
Run engine at one-third throttle, engage
PTO and raise off of seat (but do not get
off of machine) engine must initiate
shutdown after one second has elapsed if
the handles are in. The delay will be 1/2
second if the handles are out.
Run engine at one-third throttle, with brake
disengaged, move levers in and raise off
seat (but do not get off of machine) engine
must initiate shutdown after 1/2 second
has elapsed.
Again, run engine at one-third throttle, brake
engaged, and move left motion control
lever in – engine must initiate shutdown
after 1/2 second has elapsed.
Repeat again moving the right lever in,
then moving both levers in – engine must
initiate shutdown after 1/2 second has
elapsed whether operator is on seat or not.
Note: If machine does not pass any of
these tests, do no operate. Contact
your authorized Worldlawn service
dealer.
Important: It is essential that
operator safety mechanisms be
connected and in proper operating
condition prior to use for mowing.
CHECK ROPS
Service Interval: Before each use or daily
Check that mounting hardware is tight. Make
sure pins are fully engaged and secured with
cotter hairpins.
CHECK SEAT BELT
Service interval: Before each use or daily
Visually inspect seat belt for wear, cuts, and
proper operation of retractor and buckle.
Replace before operating if damaged.
CHECK FOR LOOSE HARDWARE
Service Interval: Before each use or
daily
1. Stop engine, wait for all moving parts to
stop and remove key. Engage parking
brake.
2. Visually inspect machine for any loose
hardware or any other possible problem.
Tighten hardware or correct problem before
operating.
SERVICE AIR CLEANER
Service Interval: 250 Hours
1. Stop engine, wait for all moving parts to
stop and remove key. Engage parking
brake.
2. See the Engine Owner’s Manual for
maintenance instructions.
CHANGE ENGINE OIL
Service Interval: 100 hours
NOTE: Change oil and filter after first
eight (8) hours of operation.
1. Stop engine, wait for all moving parts to
stop and remove key. Engage parking
brake.
2. Drain oil while engine is warm.
3. The oil drain valve is located on the RH side
of the engine. Place the pan under the
machine to catch the oil. Loosen the oil
drain valve and allow the oil to drain.
Tighten the oil drain valve .
4. Clean around oil fill cap and remove cap.
Fill to specified capacity and replace cap.
5. Use oil recommended in the Engine
Owner’s Manual. DO NOT overfill. Wipe up
any spilled oil from engine deck mounting
surfaces.
6. Start the engine and check for leaks. Stop
engine and recheck oil level.
To Next Page
Loading...
Need help?
General
