Programming remote transmitters:
To program replacement remotes please follow the procedures below. The
unit will hold a maximum of 2 remote codes and when programming all
other older remote codes will be deleted.
Method 1: Turn On and Off the ignition 8 times and leave it ON and wait 2
seconds. The LED will glow solid. Press button 1 of the new remote control
to set the code. The LED will flash twice and the siren will chirp twice. Press
button 1 on the second remote and the LED will flash 4 times and the siren
will chirp 4 times. Turn Off the ignition to set the codes.
Method 2: With the ignition ON, press firmly and hold in the programming
button on the back of the main unit. The LED will glow solid. Press button 1
of the new remote control to set the code. The LED will flash twice and the
siren will chirp twice. Press button 1 on the second remote and the LED will
flash 4 times and the siren will chirp 4 times. Turn Off the ignition to set the
codes.
Battery Replacement:
The M1 remotes use a “AAA” Battery and will last approximately 4 months
depending on use.
For Customer service please email:
customerservice@encoreautomotivesystems.com
For Dealer Tech Support please call 855-463-6267: Ext 3
Encore Automotive Systems
27240 Turnberry Lane Suite 200, Valencia CA 91355
www.encoreautomotivesystems.com
Encore
M1: Two-Way
Motorcycle & ATV Alarm
Professional installation only
Installation and User’s Manual
The Encore M1 is a state of the art Two-way
motorcycle alarm that utilizes advanced
detection techniques to fully secure and
protect your Motorcycle. It offers both Radar
and impact sensing and incorporates advanced
Starter or Ignition shutoff. Please read and
understand this manual before you begin your
installation.
Powered By:
E
ncore
To Next Page
Need help?
General
