Endress+Hauser Analytik Jena Biometra TRIO Series - Create New Program;Use Template

Creating, editing and saving programs Biometra TRIO
40 Version 03_19
Both programming modes show the same information but in different ways. In the
spreadsheet mode all parameters are summarized in a table. In the graphical mode for
some parameters symbols are displayed (see table below). Toggle to the spreadsheet
mode to view the settings for these parameters.
Parameter
Spreadsheet
mode
Graphical
mode
Chapter
Program name
①
①
See chapter 7.3
Heated lid temperature [°C]
②
②
See chapter 7.4
Preheat lid mode
③
③
See chapter 7.5
Step number
④
④
See chapter 7.6
Temperature [°C]
⑤
⑤
See chapter 7.6
Holding time [hh:mm:ss]
⑥
⑥
See chapter 7.6
Goto
⑦, ⑫
⑦
See chapter
7.6.1
Cycles
⑧, ⑬
⑧
See chapter
7.6.1
Temperature increment [T
(°C)]
⑨
⑨
See chapter
7.6.2
Time increment [t (s)]
⑩
⑩
See chapter
7.6.3
Ramping rate R (°C/s)]
⑪
⑪
See chapter
7.6.4
TOS step
⑭
⑭
See chapter
7.6.5
If a program has more than 6 steps, use the cursor keys to navigate in the spreadsheet
or the graphical display.
7.2 Create a new program/Use program template
Note: New programs can only be created by users with the right WRITE/DELETE OWN
PROGRAMS activated (see chapter "Edit user" p. 81). Programs of other users can only be
modified by users with the right WRITE/DELETE ALL PROGRAMS activated.
ENABLE USER TO EDIT OR DELETE OWN
PROGRAMS
1. To create a new program or to open a program template, first log in as existing
user.
2. After log in press the [PROGRAMS] button in the home screen.
PROGRAMS
The program overview screen opens: