Biometra TRIO Creating, editing and saving programs
Version 03_19 49
7.7 Insert step
To insert a new step, select a program step in the Biometra TRIO programming screen
(see Figure 16 and Figure 17) and press the [INSERT STEP] button.
By using the [INSERT STEP] button the EDIT STEP function (see chapter "Edit parameter or
step" p. 44) is activated. Set the parameters for the new step.
Note: The new step is inserted at the selected program step. If for example step 3 is
selected, the new step will be inserted at step 3. The existing step 3 is not overwritten,
but instead step 3 and all following steps will be moved one position higher. This
means, the existing step 3 will become step 4, step 4 will become step 5 and so on.
Note: If the new step is inserted to an existing loop, the number of steps within the
loop increases, whereas the number of cycles remains the same.
7.8 Delete step
To delete a step, select a program step in the Biometra TRIO programming screen (see
Figure 16 and Figure 17) and press
Note: If a step is deleted, all following steps will be moved one position lower. If for
example step 3 is deleted, step 4 will become step 3, step 5 will become step 4 and so
on.
Note: If the step is deleted in an existing loop, the number of steps within the loop is
reduced, whereas the number of cycles remains the same.
7.9 Save program
To save a program, press the [DONE] button.
On the Biometra TRIO spreadsheet or graphical programming screen. In the next pro-
gram overview screen (see Figure 25), touch the corresponding buttons to select a
user directory and a program storage location.
If the number of user directories or programs is higher than the maximum number
that can be displayed in the list, the buttons above and below the list can be used to
scroll up and down.
Note: The user directory of the logged in user is automatically preselected.
To Next Page
Loading...
