Endress+Hauser Analytik Jena Biometra TRIO - Touch Screen Calibration; Factory Settings; Fig. 56 Biometra TRIO Touch Screen Calibration Screen

Biometra TRIO Tools
83
11.1.6 Touch screen calibration
Note: The touch screen can only be calibrated by users with the right System configura-
tion activated (see section "Edit user" p. 88).
Enable a user to config. the system
configuration
To calibrate the touch screen follow the instructions and touch the screen at the center
of the displayed circle. The procedure is repeated three times at different positions of
the display. If at the end of the procedure a small cross is shown within the circle the cal-
ibration is successful.
Fig. 56 Biometra TRIO touch screen calibration screen
11.1.7 Factory settings
Note: The factory settings tool can only be executed by users with the right System con-
figuration activated (see section "Edit user" p. 88).
Enable a user to config. the system
configuration
Press the corresponding button and confirm the following security query: