Endress+Hauser Ceraphant PTP31B - 12 Overview of the Operating Menu

Overview of the operating menu Ceraphant PTP31B, PTP33B
46 Endress+Hauser
12 Overview of the operating menu
Depending on the parameter configuration, not all submenus and parameters are
available. Information on this can be found in the parameter description under
"Prerequisite".
Switch output
1)
Level 1 Level 2 Level 3 Description Details
1 x PNP 2 x PNP 1 x PNP +
4 to 20 mA
   KYL If "KYL" is shown on the display, this means that the keys of the device are locked.
To unlock the keys, see →  24
   SP1 Switch point value, output 1 →  32
   RP1 Switchback point value, output 1 →  32
   FH1 Upper value for pressure window, output 1 →  34
   FL1 Lower value for pressure window, output 1 →  34
 STL Value for 4 mA (LRV) →  35
 STU Value for 20 mA (URV) →  35
 SP2 Switch point, output 2 →  32
 RP2 Switchback point, output 2 →  32
 FH2 Upper value for pressure window, output 2 →  34
 FL2 Lower value for pressure window, output 2 →  34
   EF Extended functions
   RES Enter reset code →  54
NO No
YES Yes
   dS1 Switching delay time, output 1 →  54
   dR1 Switchback delay time, output 1 →  54
 dS2 Switching delay time, output 2 →  54
 dR2 Switchback delay time, output 2 →  54
   Ou1 Output 1
HNO NO contact for hysteresis function →  55
HNC NC contact for hysteresis function →  56
FNO NO contact for window function →  56
FNC NC contact for window function →  56
 Ou2 Output 2
HNO NO contact for hysteresis function →  55
HNC NC contact for hysteresis function →  56
FNO NO contact for window function →  56
FNC NC contact for window function →  56
 I Current output
 GTL Pressure applied for 4mA (LRV) →  36
NO
YES
 GTU Pressure applied for 20mA (URV) →  36
NO
YES