Endress+Hauser Ceraphant PTP31B - Page 47

Ceraphant PTP31B, PTP33B Overview of the operating menu
Endress+Hauser 47
Switch output
1)
Level 1 Level 2 Level 3 Description Details
1 x PNP 2 x PNP 1 x PNP +
4 to 20 mA
 FCU alarm current →  58
MIN In the event of an error: MIN (≤3.6 mA)
MAX In the event of an error: MAX (≥21 mA)
HLD Last current value (HOLD)
 OFF Switch off the current output (only visible if switch output is "ON") →  58
NO
YES
 ON Switch on the current output (only visible if switch output is "OFF") →  59
NO
YES
   UNI Unit changeover →  59
BAR Unit bar
KPA Unit kPa (depends on the sensor measuring range))
MPA Unit MPa (depends on the sensor measuring range)
PSI Unit psi
   HI Max value (maximum indicator) →  59
   LO Min value (minimum indicator) →  60
   ZRO Zero point configuration →  29
   GTZ Zero point adoption →  30
   TAU Damping →  61
   DIS Display →  62
   DVA PV Display measured value →  62
PV'/, Display the measured value as a percentage of the set span
SP Display set switch point
   DRO Display measured value rotated by 180° →  62
NO
YES
   DOF Display off →  62
NO
YES
   ADM Administration
LCK Unlocking code →  24
COD Locking code →  24
   DIAG Diagnostics
STA Current device status →  64
LST Last device status →  64
RVC Change counter →  64
   SM1 Simulation output 1 →  64
OFF
OPN Switch output opened
CLS Switch output closed