Ceraphant T PTC31, PTP31, PTP35 Operation
Endress+Hauser 15
5.2.1 Additional operating options
In addition to the operating options listed in the previous "On-site operation" section, the
ReadWin 2000 or FieldCare configuration software provides further information on the
Ceraphant T:
5.2.2 Operating Instructions for ReadWin
Comprehensive information on the ReadWin configuration software may be found in the
Operating Instructions BA00137R/09/en (refer to www.readwin2000.com).
5.2.3 Operating Instructions for FieldCare
FieldCare is an universal configuration software based on FDT/DTM technology.
!
Note!
• To configure the Ceraphant T with FieldCare the "PCP (ReadWin) Communication DTM" and
the Ceraphant T device-DTM are required.
• All devices with software version 1.01.00 or higher can be configured with FieldCare.
• The device supports only offline configuration and up-/download of parameters. The online
configuration is not supported.
• Detailed information concerning FieldCare may be found in the operation manual BA00027S
or see: www.endress.com.
Function group Description
SERV Number of switch changes for output 1
Number of switch changes for output 2
Device status
Last error to occur
INFO Tag number
Order code
Limit switch serial number
Sensor serial number
Electronics serial number
Device release
(change status)
Hardware version
Software version
To Next Page
Loading...
