Endress+Hauser Deltabar FMD71 - Page 50

Description of device parameters Deltabar FMD71, FMD72
50
Description Switching burst mode on and off.
Options • On
• Off
Factory setting Off
Burst Option (143)
Navigation Expert → Communication → HART config → Burst Option (143)
Write permission Service engineers/Expert
Description You can use this parameter to define which command is sent to the master.
Options • 1 (HART command 1)
• 2 (HART command 2)
• 3 (HART command 3)
• 9 (HART command 9)
Default output: Meas.Diff.Press. (020), Meas. Press.HP (281), Sensor Press. HP (109)
and Sensor Temp. HP (110)
• 33 (HART command 33)
Default output: Meas.Diff.Press. (020), Meas. Press.HP (281), Sensor Press. HP (109)
and Sensor Temp. HP (110)
Factory setting 1 (HART command 1)
Current Mode (144)
Navigation Expert → Communication → HART config → Current Mode (144)
Write permission Service engineers/Expert
Description Configure current mode for HART communication.
Options • Signaling
Measured value transmission by the current value
• Fixed Fixed current 4.0 mA (multidrop mode)
(Measured value transmission via HART digital communication only)
Factory setting Signaling
Bus Address (145)
Navigation Expert → Communication → HART config → Bus Address (145)