Endress+Hauser Deltabar FMD71 - Setup → Extended Setup → Current Output

Deltabar FMD71, FMD72 Description of Device Parameters
Endress+Hauser 93
Options • Next point: Enter the next point.
• Current point: Stay on the current point to correct a mistake, for example.
• Last point: Skip back to the previous point to correct a mistake, for example.
• Insert point: Insert an additional point (see example below).
• Delete point: Delete the current point (see example below).
Example Add point, in this case between the 4th and 5th point for example
• Select point 5 via the "Line number" parameter.
• Select the "Insert point" option via the "Edit table" parameter.
• Point 5 is displayed for the "Line number" parameter. Enter new values for the "X-value"
and "Y-value" parameters.
Delete point, in this case the 5th point for example
• Select point 5 via the "Line number" parameter.
• Select the "Delete point" option via the "Edit table" parameter.
• The 5th point is deleted. All of the following points are pushed up one number i.e.
following deletion, the 6th point becomes Point 5.
Factory setting Current point
Tank description (173)
Navigation Setup → Extended setup → Linearization → Tank description (173)
Write permission Operators/Service engineers/Expert
Description Enter tank description (max. 32 alphanumeric characters).
Tank content (043)
Navigation Setup → Extended setup → Linearization → Tank content (043)
Diagnosis → Measured values → Tank content (043)
Write permission Operators/Service engineers/Expert
Description Displays the level value after linearization.
14.7 Setup → Extended Setup → Current output
Alarm behav. P (050)
Navigation Setup → Extended setup → Current output→ Alarm behav. P (050)
Write permission Operators/Service engineers/Expert