Endress+Hauser Deltabar FMD72 - Diagnosis Simulation

Deltabar FMD71, FMD72 Description of Device Parameters
Endress+Hauser 107
Navigation Setup → Corrected press. (172)
Diagnosis → Measured values → Corrected press. (172)
Write permission No write permissions. Parameter is read only.6
Description Displays the measured differential pressure after position adjustment.
Sensor temp. HP (110)
Navigation Diagnosis → Measured values → Sensor temp. HP (110)
Write permission No write permissions. Parameter is read only.
Description Displays the temperature currently measured in the sensor module. This can deviate from
the process temperature.
Sensor temp. LP (283)
Navigation Diagnosis → Measured values → Sensor temp. LP (283)
Write permission No write permissions. Parameter is read only.
Description Displays the temperature currently measured in the sensor module. This can deviate from
the process temperature.
14.17 Diagnosis → Simulation
Simulation mode (112)
Navigation Diagnosis → Simulation → Simulation mode (112)
Write permission Operators/Service engineers/Expert
Description Switch on simulation and select the simulation mode. When changing the measuring
mode or the level type (Lin. mode (037)) or when the device is restarted, any simulation
running is switched off.
Options • None
• Differential pressure, → see this table, "Sim. press." parameter
• Level, → see this table, "Sim. level" parameter
• Press. HP, → see this table, "Sim. press. HP" parameter
• Press. LP, → see this table, "Sim. press. LP" parameter
• Tank content, →see this table, "Sim. tank cont." parameter
• Current, → see this table, "Sim. current" parameter
• Alarm/warning, → see this table, "Sim. error no."