Endress+Hauser Deltabar FMD72 - Onsite Display Operation

Deltabar FMD71, FMD72 Operation options
Endress+Hauser 33
User role Submenu Meaning/use
Maintenance Diagnosis Contains all the parameters that are needed to detect and analyze operating errors.
This submenu has the following structure:
• Diagnostic list
Contains up to 10 error messages currently pending.
• Event logbook
Contains the last 10 error messages (no longer pending).
• Instrument info
Contains information on the device identification.
• Measured values
Contains all the current measured values
• Simulation
Is used to simulate pressure, level, current and alarm/warning.
• Reset
• Sensor LP
• Sensor HP
Expert Expert Contains all the parameters of the device (including those in one of the submenus).
The "Expert" submenu is structured by the function blocks of the device. It thus
contains the following submenus:
• System
Contains all the device parameters that neither affect measurement nor
integration into a distributed control system.
• Measurement
Contains all the parameters for configuring the measurement.
• Output
Contains all the parameters for configuring the current output.
• Communication
contains all parameters for configuring the HART interface.
• Diagnosis
Contains all the parameters that are needed to detect and analyze operating
errors.
7.4 Operating options
7.4.1 Local operation
1
A0017650
1 Display and operating module with push buttons. Cover must be opened for operation.
7.5 Operating the device using onsite display (optional)
A 4-line liquid crystal display (LCD) is used for display and operation. The onsite display
shows measured values, dialog text as well as fault and notice messages in plain text,
thereby supporting the user in every stage of operation.
The display can be removed for easy operation.
The device display can be turned in 90° steps.
Depending on the installation position of the device, this makes it easy to operate the
device and read the measured value.