Endress+Hauser Deltabar S FMD76 - Operating Elements

Deltabar S PROFIBUS PA Operation
Endress+Hauser 13
4.2 Operating elements
4.2.1 Position of operating elements
With regard to aluminium housings (T14/T15) and stainless steel housing (T14), the operating
key is located either outside the device under the protection cap or inside on the electronic
insert. In hygenic stainless housings (T17), the operating key is always located inside on the
electronic insert. Additionally, three operating keys are located on the optional on-site display.
P01-xMD7xxxx-19-xx-xx-xx-074
Fig. 6: Operating key external, under the protective flap
1Operating key for position adjustment (zero point
correction) and total reset
P01-xxxxxxxx-19-xx-xx-xx-105
Fig. 7: Operating key and operating elements, internal
1Green LED to indicate value is accepted
2Operating key for position adjustment
(zero point-correction) or total reset
3DIP switch for hardware address
4Slot for optional display
5Slot for optional HistoROM
®
/M-DAT
6DIP-switch for locking/unlocking
measured-value-relevant parameters
7DIP-switch for damping on/off
➀
0%
Zero
Display
Sensor
on
off
0%
Zero
Address
SW
HW
1 2
3
4
5
678
on
off
Histo
ROM
on
off
➀➁
➂
➃
➄
➆➅
t
PC
21
21
CKON
3 4 5678
S DA08