Endress+Hauser Deltabar S FMD76 - Assembling and Mounting the Separate Housing Version

Installation Deltabar S PROFIBUS PA
8 Endress+Hauser
2.4 Assembling and mounting the "separate housing" version
P01-xMD7xxxx-11-xx-xx-xx-011
Fig. 4: "Separate housing" version
1In the "separate housing" version, the sensor is supplied with process connection and cable fitted.
2Cable with connection jack
4Plug
5Locking screw
6Housing fitted with housing adapter, included
7Mounting bracket suitable for wall and pipe mounting, included
Assembly and mounting
1.Connect plug (item 4) into the corresponding connection jack of the cable (item 2).
2.Plug the cable into the housing adapter (item 6).
3.Tighten the locking screw (item 5).
4.Mount the housing on a wall or pipe using the mounting bracket (item 7). When mounting
on a pipe, tighten the nuts on the bracket uniformly with a torque of at least
5 Nm.
Mount the cable with a bending radius (r) ≥ 120 mm.
r ³ 120 mm
1
2
4
5
6
7