Appendix Ecograph T, RSG35
122 Endress+Hauser
Navigation Expert → Communication → Ethernet → DHCP
Direct access code: 150002-000
Description The device can get its Ethernet settings through DHCP.
Caution: The settings determined are not displayed until after setup acceptance!
Note: The unit always gets the same IP address if the leasing time is set long enough
on the DHCP server. The PC software needs the IP address determined to establish a
connection!
Options No, Yes
Factory setting Yes
IP address
Navigation Expert → Communication → Ethernet → IP address
Direct access code: 150003-000
Description Please enter the IP address (given from your network administrator). Please talk to your
network administrator about this.
Only editable if DHCP = no.
User entry IP address
Factory setting 000.000.000.000
Subnet mask
Navigation Expert → Communication → Ethernet → Subnet mask
Direct access code: 150004-000
Description Please enter the subnet mask (given from your network administrator).
Only editable if DHCP = no.
User entry IP address
Factory setting 255.255.255.000
Gateway
Navigation Expert → Communication → Ethernet → Gateway
Direct access code: 150005-000
Description Please enter the Gateway (given from your network administrator).
Only editable if DHCP = no.
To Next Page
Loading...