7.10 Reset
On reset to factory parameters (Code 333), the values in square brackets [] are assumed.
The values in the grey fields are retained.
•
A customer echo suppression map is switched to the factory map: by setting
V3H0 = 1, it can be activated again.
•
A linearisation is set to "linear", but the table values are retained. They are
activated by setting V2H0 = 1. If necessary the values in V2H5 and V0H6 must
be entered again.
H0 H1 H2 H3 H4 H5 H6 H7 H8 H9
V0
[20] [20] [0] [5] [0] [100] [1]
V1
V2
[5] [100]
V3
[0] [1.0] [2]
[An-
tenna
tip] [0]
V4 - V7
V8
[1] [0] [30] [0] [0]
V9
Tabelle 7.3
Customer settings, factory
settings: the grey field are not
affected by a reset.
Chapter 7 Trouble-Shooting Micropilot FMR 231
44 Endress+Hauser
To Next Page
Loading...
