Endress+Hauser Gammapilot FMG50 - 5.10 Wiring Procedures and Examples

Gammapilot FMG50
Endress+Hauser 35
FMG50 with stainless steel housing (HS27)
Product structure, feature 040 "Housing, material":
Option K: 316L
FMG50 with aluminum housing (HA27)
Product structure, feature 040 "Housing, material":
Option J: aluminum
Sensor housing
• Sensor housing: 316L
• Sensor housing seal: EPDM
Measuring range marks
The measuring range marks are located on the detector pipe.
They indicate the position and length of the measuring range (sensitive area).
1
A
A0042015
1 Measuring range marks
A Measuring range
Human interface
Electronic insert / display
The electronic insert has two push buttons. Simple calibration for the level and point level can be
performed via the push buttons.
Remote operation Operation with FieldCare, DeviceCare
FieldCare and DeviceCare are Endress+Hauser asset management tools based on FDT technology.
With FieldCare, you can configure all Endress+Hauser devices as well as devices from other
manufacturers that support the FDT standard. Hardware and software requirements can be found on
the Internet at: www.de.endress.com -> Search: FieldCare -> FieldCare -> Technical data.
FieldCare and DeviceCare support the following functions:
• Configuration of transmitters in online mode
• Loading and saving device data (upload/download)
• Documentation of the measuring point
Connection options:
• HART via Commubox FXA195 and USB interface of a computer
• Commubox FXA291 via the service interface
Operation via CDI interface
Commubox FXA291
Order number: 51516983
Connects Endress+Hauser field devices with a CDI interface (Endress+Hauser Common Data
Interface) and the USB port of a computer or laptop.
TI00405C