EasyManua.ls Logo

Endress+Hauser Gammapilot FMG50 - Functional Safety; Ex Approval; Other Standards and Guidelines; Certificates

Endress+Hauser Gammapilot FMG50
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Gammapilot FMG50
38 Endress+Hauser
Functional safety
SIL 2/3 according to IEC 61508, see:
"Functional Safety Manual"
FY01007F
Ex approval
The Ex certificates available are listed in the ordering information. Observe the related Safety
Instructions (XA) and Control Drawings (ZD).
Explosion-protected smartphones and tablets
Only mobile end devices with Ex approval may be used in hazardous areas.
Other standards and
guidelines
IEC 60529
Degrees of protection provided by enclosures (IP code)
IEC 61010
Safety requirements for electrical equipment for measurement, control and laboratory use
IEC 61326
Interference emission (Class B equipment), interference immunity (Annex A – Industrial area)
IEC 61508
Functional safety of safety-related electric/electronic/programmable electronic systems
NAMUR
Association for Standards for Control and Regulation in the Chemical Industry
Certificates
The certificates are available via the Product Configurator:
www.us.endress.com/en/field-instruments-overview/product-finder -> Select product -> Configure
CE mark
The measuring system meets the legal requirements of the EU Directives. Endress+Hauser confirms
that the device has been successfully tested by applying the CE mark.
EAC
Approval for EAC is pending
Overfill prevention
WHG for point level detection is pending
Ordering information
Ordering information
Detailed ordering information is available from the following sources:
In the Product Configurator: www.us.endress.com/en/field-instruments-overview/product-finder -
> Select product -> Configure
From an Endress+Hauser Sales Center: www.endress.com/worldwide
Product Configurator - the tool for individual product configuration
Up-to-the-minute configuration data
Depending on the device: Direct input of measuring point-specific information such as
measuring range or operating language
Automatic verification of exclusion criteria
Automatic creation of the order code and its breakdown in PDF or Excel output format
Ability to order directly in the Endress+Hauser Online Shop

Table of Contents

Other manuals for Endress+Hauser Gammapilot FMG50

Related product manuals