Endress+Hauser Gammapilot FMG50 - 6.3 Configuration Locking; 6.4 Resetting to Default Configuration

Gammapilot FMG50
Endress+Hauser 45
Use
Permitted
Not recommended, observe mounting instructions
1
12
2
A
B
C
3
A0037727
A Level measurement, FMG50
B Point level measurement, FMG50
C Such horizontal mounting is not recommended
1 Retainer for pipe diameter 80 mm (3.15 in)
2 Retainer for pipe diameter 95 mm (3.74 in)
3 Retaining bracket
Mounting instructions for horizontal mounting (see Figure C): The pipe must be mounted
by the customer. It is important to ensure that the installation clamping power is sufficient to
prevent the FMG50 from slipping. The dimensions are provided in the "Dimensions of the
mounting clamps" section.
L
CAUTION
Note the following when mounting the device
‣
The mounting device must be installed in such a way as to withstand the weight of the
Gammapilot FMG50 under all anticipated operating conditions.
‣
Four brackets must be used for measuring lengths of 1 600 mm (63 in) and more.
‣
To facilitate installation and commissioning, the Gammapilot FMG50 can be configured and
ordered with an additional support (order feature 620, option Q4: "Retaining bracket").
‣
The customer must provide a clamping solution to mount the pipe. Do not use the enclosed
mounting clamps for the pipe. The retainers provided can be used for FMG50 (see Figure C).
‣
To prevent damage to the detector pipe of the Gammapilot FMG50, the maximum torque that
can be applied to tighten the retainer screws is 6 Nm (4.42 lbf ft).
Clamping device for density
measurement FHG51
FHG51 for pipes with diameter 50 to 200 mm without protective guard
SD02543F
FHG51 for pipes with diameter 50 to 200 mm with protective guard
SD02533F
FHG51 for pipes with diameter 200 to 420 mm without protective guard
SD02544F
FHG51 for pipes with diameter 200 to 420 mm with protective guard
SD02534F