Micropilot S FMR533 4 to 20 mA HART Mounting
Endress+Hauser 21
L00-FMR532xx-00-00-06-en-003
3.5 Post-installation check
After the measuring device has been installed, perform the following checks:
• Is the measuring device damaged (visual check)?
• Does the measuring device correspond to the measuring point specifications such as process
temperature/pressure, ambient temperature, measuring range, etc.?
• Is the flange marking correctly aligned (→ ä 9)?
• Have the flange screws been tightened up with the respective tightening torque?
• Are the measuring point number and labeling correct (visual check)?
• Is the measuring device adequately protected against rain and direct sunlight (→ ä 68)?
9
Ø 78
17
16
detail A
flange hub for the connection
to flanges provided by the customer
flange hub
O-Ring 85.3 x 3.53,
included
(same material as
sensor seal)
mounting:
4 bolts M6 / 90°
e.g. DIN 912
E+H UNI flange
(max. 1 bar)
detail A:
flange adapter
(see under)
mount E+H UNI flange
pull off housing
Ø 62.5
Ø 99.5
To Next Page
Loading...
