Micropilot S FMR533 4 to 20 mA HART Operation
Endress+Hauser 35
5.3.3 Factory settings (Reset)
"
Caution!
A reset sets the device back to the factory settings. This can lead to an impairment of the
measurement. Generally, you should perform a basic setup again following a reset.
A reset is only necessary if the device...
• ... no longer functions
• ... must be moved from one measuring point to another
• ... is being de-installed /put into storage/installed
User input ("reset" (0A3)):
• 333 = customer parameters
• 555 = History
333 = reset customer parameters
This reset is recommended whenever an device with an unknown "history" is to be used in an appli-
cation:
• The Micropilot is reset to the default values.
• The customer specific tank map is not deleted.
• A linearisation is switched to "linear" although the table values are retained. The table can be
reactivated in the "linearisation" (04) function group.
List of functions that are affected by a reset:
The tank map can also be reset in the "mapping"" (055) function of the "extended calibr." (05)
function group.
555 = History Reset
After mounting and aligning the equipment, carry out a history reset.
⇒
ENDRESS + HAUSER
E
+
–
• tank shape (002)
• empty calibr. (005)
• full calibr. (006)
• pipe diameter (007)
• output on alarm (010)
• output on alarm (011)
• outp. echo loss (012)
• ramp %span/min (013)
• delay time (014)
• safety distance (015)
• in safety dist. (016)
• Tank Gauging (030)
• auto correction (031)
• level/ullage (040)
• linearisation (041)
• customer unit (042)
• diameter vessel (047)
• range of mapping (052)
• pres. Map dist (054)
• offset (057)
• low output limit (062)
• fixed current (063)
• fixed current (064)
• simulation (065)
• simulation value (066)
• format display (094)
• distance unit (0C5)
• download mode (0C8)
To Next Page
Loading...
