Maintenance iTEMP TMT112
26 Endress+Hauser
9.3 Disposal
If required by the Directive 2012/19/EU on waste electrical and electronic equipment
(WEEE), our products are marked with the depicted symbol in order to minimize the
disposal of WEEE as unsorted municipal waste. Such products may not be disposed of as
unsorted municipal waste and can be returned to Endress+Hauser for disposal at conditions
stipulated in our General Terms and Conditions or as individually agreed.
10 Maintenance
The DIN rail temperature transmitter has no moving parts and requires minimal scheduled
maintenance.
Sensor Checkout
To determine whether the sensor is at fault, replace it with another sensor or connect a test
sensor locally at the transmitter to test remote sensor wiring. Select any standard, off-the-
shelf sensor for use with a DIN rail temperature transmitter, or consult the factory for a
replacement special sensor or transmitter combination.
11 Accessories
Various accessories, which can be ordered with the device or subsequently from Endress
+Hauser, are available for the device. Detailed information on the order code in question is
available from your local Endress+Hauser sales center or on the product page of the Endress
+Hauser website: www.endress.com.
PC configuration software. Please contact your supplier when ordering!
12 Technical data
12.1 Input
12.1.1 Measured variable
Temperature (temperature-linear transmission behavior), resistance and voltage.
12.1.2 Measuring range
Depending upon the sensor connection and input signal. The transmitter evaluates a number
of different measurement ranges.
To Next Page
Loading...
