Endress+Hauser iTEMP TMT142B - Page 95

iTEMP TMT142B Operating menu and parameter description
Endress+Hauser 95
Description Use this function to enter the longitude coordinates that describe the device location.
User entry –180.000 to +180.000 °
Factory setting 0°
Altitude
Navigation System → Information → Device location → Altitude
Description Use this function to enter the altitude data that describe the device location.
User entry –1.0 · 10
+20
to +1.0 · 10
+20
m
Factory setting 0 m
Location method
Navigation System → Information → Device location → Location method
Description Use this function to select the data format for specifying the geographic location. The
codes for specifying the location are based on the US National Marine Electronics
Association (NMEA) Standard NMEA 0183.
Options • No fix
• GPS or Standard Positioning Service (SPS) fix
• Differential PGS fix
• Precise positioning service (PPS)
• Real Time Kinetic (RTK) fixed solution
• Real Time Kinetic (RTK) float solution
• Estimated dead reckoning
• Manual input mode
• Simulation mode
Factory setting Manual input mode
Location description
Navigation System → Information → Device location → Location description
Description Use this function to enter a description of the location so that the device can be located in
the plant.
User entry Up to 32 alphanumeric characters (letters, numbers and special characters)
Factory setting 32 x '?'