Endress+Hauser iTEMP TMT162 - Page 21

TMT162
Endress+Hauser 21
Questionnaire
a0007374-de
When ordering a device with 2 input channels and 2 sensors with the same configuration, select the standard
setting via the product structure.
When ordering a device with 2 input channels and 2 sensors with different configuration, select "Configuration
sensor type: Y" in the product structure.
You then select the standard and extended settings using the questionnaire.
Standard setup / Standardeinstellung
Sensor 1 (S1) Sensor 2 (S2)
TC TC()B ()B()C ()C()D ()D()E ()E()J ()J
()K ()K()L ()L()N ()N()R ()R()S ()S
()T ()T()U ()U
RTD RTD
( ) Pt100 ( ) Pt100
( ) Pt500 ( ) Pt500( ) Pt1000 ( ) Pt1000
( ) Ni100 ( ) Ni100( ) Ni500 ( ) Ni500( ) Ni1000 ( ) Ni1000
( ) 2 wire ( ) 2 wire
()mV
()mV
( ) 3 wire ( ) 3 wire
( ) 10...400 Ohm
( ) 10...400 Ohm
( ) 4 wire
( ) 10...2000 Ohm
( ) 10...2000 Ohm
Unit / Einheit
()°C
( )°F ( )K ( )°R ( )mV ( )Ohm
Range / Messbereich
Low scale
(only / nur HART)
Anfang
Bitte beachten!:
Messbereich und min. Spanne
(s. Techn. Daten)
High scale
S1
S1
S2
S2
Ende
Note!:
Range and min. span
(s. Techn. data)
Expanded setup / Erweiterte Einstellung
Reference junction /
( ) intern
( ) extern
(only / nur TC)
Vergleichsstelle
[0...80°C; 32...176°F]
Compensation wire resistance /
[
0
...30 Ohm]
(only / nur RTD 2 wire)
Kompensation Leitungswiderstand
Failure mode (HART only /
()
<
3.6 mA ()
>
21.5 mA
Fehlerverhalten (nur HART)
Output (HART only) /
Ausgang (nur HART)
( ) 4...20 mA
( ) 50 Hz
( ) 20...4 mA
( ) 60 Hz
Filter
Offset
Line voltage filter/Netzspannungsfilter*
Default settings in bold
* 60 Hz is the default setting only when ordering TMT162-_______K_/
[-10...
0
...+10 K/-18...0...+18 °F]
TAG
HART:
8 char./Zeichen
FOUNDATION Fieldbus/
PROFIBUS PA:
32 char./Zeichen
Questionnaire Endress+Hauser iTEMP temperature transmitter
Customer specific setup / Kundenspezifische Einstellung
..
,
,
[
0
, 1, 2,..., 60s]