Endress+Hauser iTEMP TMT162 - Page 21

iTEMP TMT162 Operation options
Endress+Hauser 21
3 mm
4.
3.
2.
1.
90°
90°
ON
OFF
A0011211
Procedure for setting the DIP switch or activating the proof test:
1. Remove the cover clamp.
2. Unscrew the housing cover together with the O-ring.
3. If necessary, remove the display with retainer from the electronics module.
4. Configure the hardware write protection WRITE LOCK accordingly using the DIP switch.
In general, the following applies: switch to ON = function enabled, switch to OFF =
function disabled. If performing a SIL commissioning test and a proof test, make a
device restart using the button.
Once the hardware setting has been made, re-assemble the housing cover in the reverse
order.