Incoming acceptance and product identification iTEMP TMT162
6 Endress+Hauser
2.3 Workplace safety
When working on and with the device:
‣
Wear the required personal protective equipment as per national regulations.
2.4 Operational safety
• Operate the device only if it is in proper technical condition, free from errors and faults.
• The operator is responsible for the interference-free operation of the device.
Power supply
‣
The device must only be powered by a 11.5 to 42 V
DC
voltage supply according to NEC class
02 (low voltage/current) with short circuit power limitation to 8 A/150 VA.
Hazardous area
To eliminate a danger for persons or for the facility when the device is used in the hazardous
area (e.g. explosion protection or safety equipment):
‣
Based on the technical data on the nameplate, check whether the ordered device is
permitted for the intended use in the hazardous area. The nameplate can be found on the
side of the transmitter housing.
‣
Observe the specifications in the separate supplementary documentation included as an
integral part of these instructions.
Electromagnetic compatibility
The measuring system complies with the general safety requirements as per EN 61010-1, the
EMC requirements as per the IEC/EN 61326 series and the NAMUR recommendations NE 21
and NE 89.
2.5 Product safety
This measuring device is designed in accordance with good engineering practice to meet state-
of-the-art safety requirements, has been tested, and left the factory in a condition in which it
is safe to operate.
It meets general safety standards and legal requirements. It also complies with the EU
directives listed in the device-specific EU Declaration of Conformity. The manufacturer
confirms this by affixing the CE mark to the device.
3 Incoming acceptance and product identification
3.1 Incoming acceptance
Proceed as follows on receipt of the device:
1. Check whether the packaging is intact.
2. If damage is discovered:
Report all damage immediately to the manufacturer.
To Next Page
Loading...
