Operating menu and parameter description iTEMP TMT162
100 Endress+Hauser
Calibration countdown
Navigation Expert → Sensor → Diagnostic settings → Calibration countdown
Description Use this function to view the time remaining until the next calibration.
Calibration countdown only runs when the device is active. Example: If the calibration
counter is set to 365 days on January 1, 2011 and no electricity is supplied to the
device for 100 days, the alarm for the calibration appears on April 10, 2012.
14.3.3 "Output" submenu
Lower range value→ 72
Navigation Setup → Lower range value
Expert → Output → Lower range value
Upper range value → 72
Navigation Setup → Upper range value
Expert → Output → Upper range value
Failure mode→ 77
Navigation Setup → Advanced setup → Current output→ Failure mode
Expert → Output → Failure mode
Failure current → 78
Navigation Setup → Advanced setup → Current output→ Failure current
Expert → Output → Failure current
Current trimming 4 mA → 78
Navigation Setup → Advanced setup → Current output→ Current trimming 4 mA
Expert → Output → Current trimming 4 mA
To Next Page
Loading...
