Operating menu and parameter description iTEMP TMT162
114 Endress+Hauser
Navigation Diagnostics → Measured values → Sensor n value
Expert → Diagnostics → Measured values → Sensor n value
Sensor n raw value
n = Stands for the number of sensor inputs (1 and 2)
Navigation Expert→ Diagnostics → Measured values → Sensor n raw value
Description Use this function to display the non-linearized mV/Ohm value at the specific sensor input.
Device temperature → 88
Navigation Diagnostics → Measured values → Device temperature
Expert → Diagnostics → Measured values → Device temperature
"Min/max values" submenu
Detailed description → 88
The following section provides a description of the additional parameters in this
submenu that only appear in the Expert mode.
Reset sensor min/max values
Navigation Expert → Diagnostics → Measured values → Min/max values → Reset sensor
min/max values
Description Reset the peakhold indicators for the minimum and maximum temperatures measured at
the sensor inputs.
Options • No
• Yes
Factory setting No
Reset device temp. min/max values
Navigation Expert → Diagnostics → Measured values → Min/max values → Reset device temp.
min/max values
Description Reset the peakhold indicators for the minimum and maximum electronic temperatures
measured.
To Next Page
Loading...
